How do I reset or rebalance my board?
We get quite a few emails about this so here goes... Your board from time to time may need a reset, this is easy to do:
How to reset your board:
1. Charge the board for two hours to make sure its fully charged.
2. Turn off board and make sure the board is level (straight and not bent).
3. Turn off the board.
4. Hold down the “on” button for 45 seconds. The led lights on the front should come on under the board and start flashing and you will hear a couple of beeps. Let them continue for the full 45 seconds.
5. Turn off the board.
6. Turn the board back on again and this reset has fixed the fault.